Hotpoint washer i have a hotpoint washing machine and i have been told the bearings have gone? - washing machine bearings
i dont much money, if I expected to repair my car. Where can I find a model wma34 start Thanks
Saturday, January 2, 2010
Washing Machine Bearings Hotpoint Washer I Have A Hotpoint Washing Machine And I Have Been Told The Bearings Have Gone?
Subscribe to:
Post Comments (Atom)
1 comments:
It is a big job, has done a lot, Laundry ex.
Disconnect water lines preserved.
Top
Face off outside the door seal
Remove most of the cases before and Drum, double trapeze loose on the back of the machine.
Disconnect the hose from the pump
Disconnect the hose reel to make soap
Lift Frame Drum, remove all belts, etc.
Drum Stand in the brick house at the back to keep the level
Value clips straight black drum and remove the heating
Remove belt from motor
Undo the large nut on the back with a wrench, while the drum is kept constant
Press alloy wheels / Spider screws carefully with a hammer and / Delete
Replace the screw and nut to protect the end of the wire
Great mass of hammer hits the shaft through the nut and then pull back
Inner drum is now out
The bearings are exposed
Knock Out front bearing on the back with a hammer and a thin piece of solid metal dish (like a large mat-engine)
Label exit early
Knock, new steps forward
The bearings are outside
Knock gently rolling back (a little grease CAVity before setting) all the way and put the new seal on the front
Reverse the process and the fascia in the drum
Reversal of the entire
It is a pig of a job. An engineer I can for a quick return-70th New bearing kits are about 10 pounds.
You can tell if the bearings are gone, when there excessive noise or play on the drum by pressing the upper and lower lip of the drum.
Problems can arise when the installation as a camp ... Storage can be in a spider web of plastic outer drum can be divided to break rusted ...
Post a Comment